Avid Technology Stage 48 User Manual

Stage 4814
3 To lock the Top Panel in the vertical position, tighten the two
interior captive thumbscrews located on the top left and top
right sides of the console.
4 Locate the card and loosen the two interior captive thumb-
screws that secure the card to the console chassis.
5 Disconnect the 50-pin ribbon cable by pushing the retaining
clips outwards. Note the location and orientation of the cable.
6 On the back of the console, remove the four screws that se-
cure the card to the console chassis.
7 Gently slide the card out of the slot. You may need to use a
screwdriver or other flat-edged tool to pry the card away from
the slot.
8 If you are finished removing cards, do the following to close
and secure the Top Panel:
• Loosen the captive thumbscrews and carefully lower the
Top Panel into position.
• Replace the screws that secure the Top Panel to the con-
sole chassis.
Figure 11. Tightening the top left captive thumbscrew
Figure 12. Loosening the captive thumbscrews
Figure 13. Disconnecting the 50-pin ribbon cable
Leave the disconnected ribbon cable in the console. Do not
attempt to remove it.
Do not pry the card from the top. Doing so can damage the
copper strips located along the top of the card.
Figure 14. Removing the card from the slot

Avid Technology Stage 48 Specifications

General

Brand	Avid Technology
Model	Stage 48
Category	Recording Equipment
Language	English