EN23EN 22
1 - SETTINGS INTERFACE
Indicators
• L0 = Green LED (switched off when the card is
on standby)
• L1 to L4 = Red LEDs to display information
concerning settings, events (or errors) or battery
status.
Buttons
PROG = Enter or exit settings menus.
“-” / “+” = Select a menu item, set a value, navigate
the event log.
OK = Enter sub-menus, confirm a setting, view the
battery voltage or history of events, enter manual
control mode.
Important notes:
• Buttons can be pressed and released or pressed
and held (for 3 seconds). When the instructions
below indicate “press the PROG button”, the
button must be pressed and released. When the
instructions indicate “press the PROG button
for 3s” or “PROG 3s”, the button must be
pressed and held.
• In the instructions below, the operations to be
performed with the buttons will be described
from MENU 0. It’s the display menu that appears
just after the power has been switched on for
example, just after the gate has moved (before
standby) or even when the card is on standby (in
this case, the green LED L0 is switched off).
• To make sure you are at MENU 0 of the display,
press PROG 2 or 3 times and only the green LED
should be switched on.
When the user performs no action on a button
for 15 seconds, the system automatically goes
back to MENU 0.
2 - BASIC SETTINGS (MENU 1)
2.1 - MENU STRUCTURE
After it is switched on, all LEDs will be turned
off except the green LED
• If the green LED is off, the card is on standby
mode. Press PROG once (press and release) to
activate the card. If no lights turn on, check that
the power connections are correct.
• Lit up red LEDs are an error code. Check the error
code table for the meaning. (If the card has already
worked before, the last error code appears. This
does not mean that there is a problem with the
card).
• To clear the display of an error code, press and
release PROG once.
Now to enter settings menu 1 (MENU 1), press
PROG for 3 seconds and LED L1 will turn on.
• Menu item number 1 is selected. Press + or – to
select another menu item and the red LED for that
item will turn on accordingly.
• When a menu item is selected, press OK to view
and change the related setting. See the chart
below. The + and – buttons must then be used to
change the setting value, and the OK button must
be pressed to confirm it. If you do not wish to
change a setting, you can exit by pressing PROG
repeatedly (until only the green LED is lit).
D - BEGINNING OPERATION
To Next Page
Loading...
