User’s Manual
2. Press both sides of the ADF snap-in pad module inwardly
with your fingers to pull out the ADF snap-in pad from the
slot.
Figure 8-8
Assembling Procedure
1. Take out the ADF pad module from the box.
2. Press both arms of the ADF snap-in pad module inwardly
with your two fingers.
3. Place it into the holes until it snaps into place.
Note:
Consumables must be replaced regularly. It is
recommended to purchase new consumables in advance so
that they can be replaced before the end of their life time.
The replacement cycle is based on the use of A4 (80 g/m2
[20 lb]) wood-free paper or plain paper. The actual cycle
varies according to the type of used paper and how
frequently the scanner is used and cleaned.
Use only the specified consumables.
To purchase consumables, contact the store where you
purchased the scanner or an authorized scanner service
provider.
To Next Page
Loading...
