34 Cyclades ACS 6000 Advanced Console Server Command Reference Guide
alias:
127.0.0.1/add
172.26.31.164/
7. Enter cd <IP_address>/settings to navigate to the level where you can perform additional
configuration of the host entry.
--:- hosts cli-> cd 172.26.31.164/settings
8. Enter show to view the additions to the host table and the Settings option.
--:- 172.26.31.164 cli-> show
ip: 172.26.31.164
hostname = sharedacs6000
alias =
Wiz command
The wiz command allows administrators to easily and quickly perform the initial network
configuration of the eth0.
At the command prompt at the units level, enter
wiz to view the current IP configuration. To change
the IP configuration, press
Tab to move through the parameters, and press Esc + Tab to edit the
selected parameter. When you are finished, enter
yes to confirm that all parameters are correct and
to save the new parameters.
--:- units cli-> wiz
eth0:
ipv4 address: 172.26.30.240
ipv6 address:
status = enabled
ipv4_method
(*) dhcp
( ) static
address = 192.168.160.10
mask = 255.255.255.0
gateway =
( ) ipv4_address_unconfigured
ipv6_method
( ) stateless
( ) dhcpv6
To Next Page
Loading...
