Chapter 3: CLI Appliance Settings Options 43
NOTE: To set a rule, you must enable the interface, set the rule for the interface and physically connect the
interface to the network.
Appliance_Settings/IPSec(VPN)
Enter cd appliance_settings/ipsec(vpn) to navigate to the ipsec(vpn) level.
--:- units cli-> cd appliance_settings/ipsec(vpn)
Table 3.9: Firewall Options
Firewall Navigation Tree
ipv4_filter_table
input
forward
output
ipv6_filter_table
input
forward
output
Table 3.10: IPSec(VPN) Options
IPSec(VPN) Navigation Tree
connection
name =
authentication_protocol = (ah / esp)
boot_action = (add / route / start / ignore)
remote
id =
ip_address =
next_hop =
subnet =
local
id =
To Next Page
Loading...
