h. Set & Clear Preset
A preset is a specific position of a camera that you can save in the camera. A preset is assigned to a number
from 0-9.
1. To set a preset, first point the camera in a specific direction and a specific zoom position.
2. Assign the position to a number with the button Set Preset.
3. Call the preset by pressing one of the numbers 0-9 on the remote control.
Set Preset: [SET PRESET]→[<number>]
Call Preset: [<number>]
Clear Preset: [CLEAR PRESET]→[<number>]
If the position preset '0' has been stored, this position will be called after initialization.
Use ONLY presets between 0-9 when using the Remote Control. For presets 10 or higher you need a serial or IP
connection.
i. PTZ Keys (up/down/left/right)
Use these keys to move the camera in the desired direction.
j. Home
Use this key to turn automatically the camera to its start up position. The camera will zoom out and turns
to a position with the lens straight forward. This affects only the Pan, Tilt and Zoom position and NOT the
focus level of the camera, or exposure and white balance settings.
k. BLC ON/OFF
Use this key to enable / disable the Back Light Compensation feature.
l. Menu
1. Use the Menu button to open the On Screen Display (OSD) menu. This menu is visible on the HDMI/
SDI output.
2. If the menu is not in English, press [*]→[#]→[4] to change the Menu language into English.
m. Function Keys (F1/F2/F3/F4)
Used to configure the IR channel of the camera. See 'c. Camera Select' above for instructions.
n. Blank Buttons
These buttons have NO function with this camera.
48
To Next Page
Loading...
Need help?
General
