Handling Precautions
Always take the camera by its base and do not move the position of the lens manually. See below.
Figure 5: Handling Precautions
Unpacking the Camera
Execute the following steps to unpack the camera and associated components:
1. Open the box.
2. Verify that the contents of the box exactly matches the items as described in Package Contents
on page 13. If this is NOT the case, contact Avonic and stop here.
The camera should be in its protective foam as follows:
Figure 6: Camera in Foam
3. Verify that the plastic camera bag is sealed. If this is NOT the case, contact Avonic and stop here.
4. Break the seal of the sealed camera bag.
5. Take the camera out of the bag. Be sure to follow the Handling Precautions on page 14
while doing so.
6. Install the camera following the steps as described in the chapter MOUNTING AND
INSTALLATION on page 15
Return Procedure
If, for any reason, you have to return the camera to Avonic, Execute the following steps:
1. Place the camera back in its protective foam. Verify that the lens is in HORIZONTAL position!
2. Place the camera with all of its components in the box.
3. Verify that the contents of the box exactly matches the items as described in Package
Contents.
4. Contact Avonic for the Return Procedure.
14
To Next Page
Loading...
Need help?
General
