REMOTE OPERATION
27
Network Backup
Click “ ” (Miscellaneous Control) → “ ” (Backup) to go into the “Backup” page as follows, and you can
select a specific time range or event to make a video backup remotely.
Note: Before enabling the network backup function, make sure the DVR is not in the playback mode, or
the DVR will stop playback.
Function Description
IP Address / Port / User Name / Password Check if the network connection information of the DVR within which
contains the video data you need is correct.
HDD Number / Channel Specify the hard disk (HDD Number) and channel number (Channel)
within which have the video data you need.
Download by Time Specify the time range within which has the video data you want in the
“Start Time” and “End Time” columns.
Download by Event Select an event log from the event list. This list shows all logs in the
specified DVR from the latest to the earliest.
‧To quickly find the events you need, check or uncheck the event type
“System” / “Manual” / “Alarm” / “Motion”, and select the log you
want.
‧To view the earlier or later logs that are not shown in the current
page, click “Prev. Page” or “Next Page”.
‧To refresh the event list, click “Reload”.
File Path Assign the location where the backup files are saved.
Simultaneous Playback To view the backup images simultaneously when the download
process is in progress, select the checkbox “Simultaneous Playback”.
You will see the backup images while the images are being
downloaded to the PC or notebook.
To simply backup images without previewing, deselect the checkbox
“Simultaneous Playback”. You will only see a message box indicating
the total time needed, the current status and the saving location.
Download / Cancel Click “Download” to start or “Cancel” to discard the video backup.
To Next Page
Loading...
Need help?
General
