EasyManuals Logo

Avtech Room Alert User Manual

Avtech Room Alert
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
16 AVTECH Software Inc.
Conguration And Setup Screens Room Alert 26W
Internal Power Sensor
The internal Power Sensor is enabled by checking the ‘Alarm On Power Loss’ checkbox. The Room
Alert 26W unit has a built-in UPS and will remain on long enough to send an alert if a main power
failure should occur. If you would like to change the sensor label for the internal Power Sensor, enter the
new name in the eld next to the ‘Power Sensor label.
Internal Flood Sensor
The internal Flood Sensor, as mentioned above, requires the purchase of an AVTECH Flood Sensor Cable.
If a Flood Sensor Cable has been obtained and connected, the Room Alert 26W unit can be congured to
monitor the sensor by checking the Alarm On Water Detection checkbox. If receiving an alert notication on
cable disconnect is also desired, be sure to check theAlarm On Disconnection checkbox.
Digital Sensors
The alert thresholds for any attached digital sensors are entered in the ‘Digital #’ labels with ‘#’
representing the digital port number the sensor is connected to. The sensor label for that corresponding
sensor can be updated in the eld next to the ‘Digital Sensor label and the sensor type of the sensor will
be displayed directly below it. High and low thresholds for the temperature and humidity (if the sensor
is a Temperature/Humidity Sensor) are entered in the ‘High’ and ‘Low’ columns. Temperature thresholds
must be entered in the temperature scale selected on the ‘Advanced’ tab. Humidity thresholds must be
entered in percent Relative Humidity (%RH). If the sensor readings differ from a known temperature or
humidity at the sensor location, they can be calibrated using the ‘Adjust’ column.

Other manuals for Avtech Room Alert

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Avtech Room Alert and is the answer not in the manual?

Avtech Room Alert Specifications

General IconGeneral
Device TypeEnvironmental Monitoring Device
Monitored ParametersTemperature, Humidity, Water, Power, Motion, Airflow, Light, Sound
ConnectivityEthernet
Alerting MethodsEmail, SMS, SNMP
Power SourceAC Power (100-240V), Optional Battery Backup
Operating Temperature32°F to 122°F (0°C to 50°C)
DimensionsVaries by model
WeightVaries by model
CompatibilitySNMP, Web browsers
WarrantyVaries by model, typically 1 year

Related product manuals