Avtech Room Alert - Additional Screens And Interfaces; Network and Security Configuration

22 AVTECH Software Inc.
Additional Screens And Interfaces Room Alert 26W
Additional Screens And Interfaces
Network
The ‘Network’ tab of the Room Alert 26W ‘Settings’ screen is used to update the network settings of the
Room Alert 26W unit. The network settings can also be updated using the AVTECH Device Discovery
Utility. To congure the Room Alert 26W unit to obtain an IP address automatically using DHCP, check
the ‘Use DHCP’ checkbox and click the ‘Save Settings’ button. To congure the unit with a static IP
address, uncheck the ‘Use DHCP’ checkbox, enter the new static IP address, gateway IP address, DNS
server IP address, and subnet mask in the appropriate elds and click the ‘Save Settings’ button.
NOTE: If conguring static IP settings on the Room Alert 26W unit, be sure that the settings assigned are valid for the current
location of the Room Alert 26W unit and that there are no other devices assigned to the same IP address. DO NOT set an IP
address that is outside of your subnet or you may not be able to see or discover the Room Alert 26W unit.
Security
The ‘Security’ tab of the Room Alert 26W ‘Settings’ screen is used to congure a password for entry to
the Room Alert 26W ‘Settings’ screen. Be sure that the password entered contains only alphanumeric
characters, special characters are not supported. Enter the password again in the second eld for
verication and click the ‘Save Settings’ button.