20 AVTECH Software Inc.
External Sensor Options Room Alert 26W
External Sensor Options
Digital Temperature Sensor (TMP-SDT-SEN)
The AVTECH Digital Temperature Sensor provides a real-time digital temperature
reading at the location of the temperature probe. The temperature range is from
-67° to 257° Fahrenheit and/or -55% to 125° Celsius. Accuracy is within +/- 0.5
degrees. This is an instant ‘plug & play’ sensor that connects to one of the external
environment sensor channels via an RJ-11 cable.
Digital Temperature/Humidity Sensor (RMA-DTH-SEN)
The AVTECH Digital Temperature/Humidity Sensor provides a real-time digital
temperature and digital humidity reading at the location of the sensor probe. The
temperature range is from -67° to 257° Fahrenheit and/or -55% to 125° Celsius.
Accuracy is within +/- 0.5 degrees. The humidity range is from 0 to 100 percent Relative
Humidity (%RH). Accuracy is within +/- 3.5%. This is an instant ‘plug & play’ sensor
that connects to one of the external environment sensor channels via an RJ-11 cable.
Digital Power Sensor (RMA-PS2-SEN)
The AVTECH Digital Power Sensor allows real-time voltage, amperage, wattage
and overall power consumption readings for the device plugged into it. Alerts can be
initiated based upon consumption levels. This is an instant ‘plug & play’ sensor that
connects to one of the external environment sensor channels via an RJ-11 cable.
Flood Sensor (RMA-F008-SEN, RMA-F024-SEN)
The AVTECH Flood Sensor is available with a standard 8´ or 24´ ood sensor cable and
allows a real-time notication of ood or water leakage wherever the attached ood sensor
cable is located. This is an instant ‘plug & play’ sensor that connects to one of the switch
sensor contact sets via a low voltage 2-wire cable.
Sound, Light & Entry Sensor (RMA-SLE-SEN)
The AVTECH Sound, Light & Entry Sensor allows real-time monitoring for sound and light
at the location of the sensor. This sensor also includes a set of switch sensor contacts and
an AVTECH Room Entry Sensor. Each sensor can be monitored independently or an ‘any
sensor’ contact set allows all sensors to be monitored via a single cable. Any switch sensor
can be attached to the switch sensor contacts. This is an instant ‘plug & play’ sensor that
connects to one or more of the switch sensor contact sets via a low voltage 2-wire cable.
To Next Page
Loading...
Need help?
General
