Please note, that if the converters are connected over the internet, the Remote IP Address of
the client will be a public IP address of the server, not the internal server IP address presented
as the Device IP Address on Figure 23. The network administrator on the server side will be
required to configure port forwarding to open internet access to the converter in the server
mode.
When the converter is configured as a client, it will still act as a server accepting connections
on the Device Port from other clients. This adds versatility to the converter configurations since
the same converter can be used together with both: client and server communication nodes.
As an example, the user can establish an unlimited number of daisy-chain client-server
connections, see: Figure 25.
To Next Page
Loading...