31
AXIS 207W/AXIS 207MW - System Options
Network - Basic TCP/IP Settings
Network Settings
Click the View
button to view the current network settings.
Network Interface Mode
This setting controls how the wired and
wireless network interfaces are used. It is not
possible to use both interfaces simultaneously.
IPv4 Address Configuration - Ethernet
These settings are grouped according to the network interface
and the version of Internet
Protocol (IP). The AXIS 207W/AXIS 207MW supports both IP version 4 and IP version 6.
Both versions may be enabled simultaneously, and at least one version must always be
enabled.
When using IPv4, the IP address for the camera can be set automatically via DHCP,
or a
static (fixed) IP address can be set manually. If IPv6 is enabled, the camera will receive an
IP address according to the configuration in the network router.
There are also options for setting up notification of changes in the IP
address, and for
using the AXIS Internet Dynamic DNS Service. For more information on setting IP
addresses, please see the online help .
Notes:
• DHCP is a protocol for automatic IP address assignment on a network. IP address assignment via DHCP may
lead to the situation where the IP address changes and you lose contact with the camera. Configure the
options for notification of IP address change (under Services) to receive notification from the camera when
the IP address changes.
• Alternatively, if your DHCP server can update a DNS server, you can access the AXIS 207W/AXIS 207MW by
host name, which is always the same, regardless of the IP address.
IPv4 Address Configuration - Wireless
It is possible to have a separate configuration for IPv4
Address - wireless. The
configuration is similar as for the Ethernet option.
IPv6 Address Configuration - Wireless
It is possible to have a separate configuration for IPv6
Address - wireless. The
configuration is similar as for the Ethernet option.
To Next Page
Loading...
Need help?
General
