AXIS 221/223M Installation Guide Page 13
ENGLISH
Accessing the AXIS 221/223M from the Internet
Once installed, your AXIS 221/223M is accessible on your local network (LAN). To access the
camera from the Internet, network routers must be configured to allow incoming traffic, which
is usually done on a specific port. Please refer to the documentation for your router for further
instructions.
For more information on this and other topics, please visit the Axis Support Web at
www.axis.com/techsup
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Reset/control button (rear panel) and reconnect power.
3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15
seconds), then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the camera is
reset to the factory default settings.
5. Re-install the AXIS 221/223M using one of the methods described in this document.
More information
It is also possible to reset all parameters, except the IP parameters, to the original factory
settings via the web interface. For more information, please refer to the online help and the
user’s manual. The AXIS 221/223M User’s Manual is available from the Axis Web site at
http://www.axis.com or from the Axis Network Video CD.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
