Axis 221 Installation Guide

Page 4 AXIS 221/223M Installation Guide
Connections
1. Connect the AXIS 221/223M to your network using a standard network cable.
2. Connect power, using one of the 3 supported methods listed below:
• The supplied power adapter.
• Power over Ethernet (PoE) via the network cable. This will automatically be detected if
available via the network.
• The power connector block on the rear panel. See the illustration above.
Status
indicator
Zoom puller
(Tele/wide)
Focus puller
DC-Iris
Serial number
on underside
label
Power adapter
connector
10-pin I/O terminal
connector
Power
Power indicator
Network indicator
Reset/Control
button
connector
RS-232
connector
block
Network
(also PoE)
connector
DC-Iris
control cable
DC-Iris
control cable
Power adapter
connector
RS-232
connector
Network
(also PoE)
connector
Power and network indicators
Reset/Control
button
Audio out
Audio in
connector
10-pin I/O terminal
AXIS 223M - Rear view
AXIS 221 - Rear view
AXIS 221/223M
Front view
Power connector
block

Axis 221 Specifications

General

Maximum resolution	640 x 480 pixels
Supported video modes	-
Video formats supported	MPEG4
Camera shutter speed	1/25000 - 2 s
Minimum illumination	0.08 lx
Sensor type	CCD
Progressive scan	Yes
Optical sensor size	1/3 \
Optical zoom	- x
Focus adjustment	1.0
Focal length range	3 - 8 mm
Built-in HDD	No
Flash memory	8 MB
Internal memory	32 MB
Type	IP security camera
Certification	EN 55022 B, EN 55024, EN 61000-3-2, EN 61000-3-3, \\r EN 61000-6-1, EN 61000-6-2, FCC 5 B B, \\r VCCI B, C-tick AS/NZS CISPR22, ICES-003 B, \\r EN 60950-1
Placement supported	Indoor
Connectivity technology	Wired
Form factor	Bullet
Product color	Gray
Housing material	Aluminum
Ethernet LAN (RJ-45) ports	1
Cabling technology	10/100Base-T(X)
Supported network protocols	IPv4/v6, HTTP, HTTPS, QoS Layer 3 DiffServ, FTP, SMTP, Bonjour, UPnP, SNMPv1/v2c/v3 (MIB-II), DNS, DynDNS, NTP, RTSP, RTP, TCP, UDP, IGMP, RTCP, ICMP, DHCP, ARP, SOCKS
AC input voltage	24 V
Power source type	PoE
Power consumption (typical)	7.5 W
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	20 - 80 %
Compliance industry standards	IEEE 802.3a

Weight and Dimensions

Weight	550 g