AXIS P1346 Network Camera
System Options
The following traps are available:
•Coldstart
•Warmstart
•Linkup
• Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNMP v3, HTTPS must be enabled, see HTTPS, on page 41. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to f actory default settings, on page 50.
UPnP
TM
The Axis product includes supp ort for UPnP
TM
.UPnP
TM
is enabled by default and the product is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can be disable d under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range a nd multicast settings are configured under System Options > Network > RTP.
The RTP port range defines the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always Multicast Video and/or Always Multicast Audio to start multica st stre aming w ithout opening an RTSP session.
Bonjour
The A xis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by operating
systems and clients that s upport this protoc
ol.
Bonjour can be disabled under System Op
tions > Network > Bonjour.
Storage
SD card
The SD card is managed on the System Options > Storage page. Click SD card to open Storage Management.
Mounting is done automatically when the card is inserted or when the product boots. SD cards are no rmally preformatted when
purchased, b u t if needed, click Format to forma t the card.
Format an SD card so that it can be written t o one of two available options — VFAT and ext4. During the formatting any previous
data stored on the disk will be lost. The recommended format is ext4, due to its resilience against data loss if the card is ejected
or if there is abrupt power loss. A third-party ext4 dr iver or a pplication is also needed to acces s the file system from Windows.
Note that most SD cards are pre-fo rmatted w ith v FAT when purchased. The Check D isk o ption is used to check for errors on the SD
card and only works for the file system ext4. The Repair option repairs the SD card of errors in the file system ext4. For vFAT file
system use a ca rd reader or PC to perform card maintenance.
Note
To prevent corruption of recordings, the SD car d should always be unmounted b efo re removal.
47
To Next Page
Loading...
Need help?
General
