AXIS P1347 Network Camera
System Options
Advanced
Scripting
Scripting allows experienced users to customize and us e their own scripts.
Caution
Improper use may cause unexpected behavior and loss of contact with the Axis product.
Axis strongly recommends that you do not use this function unless you understand the consequences. Axis Support does not provide
assistance for problems with customized scripts.
To open the Script Editor, go to System Options > Advanced > Scripting. It is recommended to create a backup file before
customizing the scripts. If a script causes problems, reset the product to its factory d efault settings, see page 50.
For more information, see www.axis.com/developer
File Upload
Files, for example w eb pages and images, can be uploaded to the Axis pro duct and used as custom settings. To upload a file, go
to System Options > Advanced > File Upload.
Uploaded files are accessed through http://<ip address>/local/<user>/<file name> where <user> is the
selected user group (viewer, operator or administrator) for the uploaded file.
Plain Config
Plain Config is for advanced users w ith experience of Axis product configuration. Most parameters can be set a nd modified from this
page. Help is available from the standard help pages.
To open Plain Config, go to System Options > Advanced > Plain Config.
Reset to factory default settings
This will reset all parameters, including the IP addres s, to the factory
default settings:
1. Disconnect power from the product.
2. Press and hold the Control button and recon
nect power (see Ha rdware overview, on page 5 ).
3. Keep the Control bu tton pressed for a
bout 15 seconds until the Status indicator flashes ambe r.
4. Release the Control button. Th
e process is complete after about 1 minute (when the Status indicator turns green). The
product has been reset to the factory default settings. The default IP address is 192.168.0.90
5. Re-assign the IP address.
6. Refocus the product.
It is also possible to reset parameters to factory default via the web interface. Go to Setup > System Options > Maintenance.
50
To Next Page
Loading...
