The following needs were identified for a user group:
The table below shows the Recording and Camera settings that fulfill the needs listed above.
Need Recording settings Camera settings
Maximum image and audio
quality
Resolution: 1080p
Audio: On
Select Optimized for post-
processing
Record before pressing button Pre-buffer : On
Length: 90s
Audio: On
Record location data Location data : On
Operate without being
detected
Select Allow silent mode
Turn off the microphone while
recording
Select Allow audio
recording off
1. Enables dual audio channels, optimized for processing in raw format. This results in a
slightly higher bitrate.
2. The pre-buffer has a dedicated space on the camera storage. When using the maximum
resolution 1080p in very complex scenes with a lot of movement, or in low light, the pre-
buffer memory can get full, resulting in a slightly shorter pre-buffer time than configured
in AXIS Body Worn Manager.
3. Location data is for outdoor use only. We recommend turning Location data off for indoor
use.
Get maximum image and audio quality.
Record events (video and audio) that happened during the 90 seconds before the
recording button (Front button) was pressed.
Record data showing the location where the recording took place.
Enable the camera user to operate without being detected, by allowing the camera user
to turn off all camera feedback (LED, sound, vibration).
Allow the user to turn off the microphone while recording.
(1)
(2)
(3)