Why is no Axis W10 assigned when tapping the RFID tag?
If no camera is assigned to the user when the user taps the RFID tag on the reader (using self-assign), wait until a camera is ready for use. A camera is ready for use when it has enough storage and battery, and it has the same firmware version as the rest of the system.
How to fix no audio in Axis Digital Camera recordings?
If there is no audio in your Axis Digital Camera recordings, make sure audio is turned on in the camera profile within AXIS Body Worn Manager.
What to do if my Axis Digital Camera doesn't record?
Your Axis Digital Camera might not be recording because the camera storage is full (storage status is red). Try docking the camera to resolve this issue. Other possible causes are: pre-buffer video is not complete because pre-buffer time is shorter than configured in AXIS Body Worn Manager; recording started directly after the previous recording was ended; when using the maximum resolution 1080p in very complex scenes with a lot of movement, or in low light, the pre-buffer memory can get full.
What to do if Axis Security Camera doesn't record?
If your Axis Security Camera isn't recording, the most likely cause is that the camera storage is full. In this case, dock the camera.
What to do if Axis Action Cameras operation status flashes green and battery is red?
This behavior occurs when the camera profile setting Low battery warning is set to Periodic or Periodic reinforced. Charge the Axis Action Camera. If the camera is in the docking station, make sure it’s docked properly because the battery is about to run out.
Why are all LEDs off when Axis Action Cameras are docked?
If you are using fixed camera assignment, no user is assigned to the camera, so assign a user to the camera. If you are using self-assign camera assignment, this means that the camera is ready to be self-assigned.
Why is there no location data in the text overlay of my Axis Security Camera?
If there is no location data in the text overlay of your Axis Security Camera, location data might be turned off. Turn Location data on in the camera profile to resolve this.
Why doesn't the LED display work on my Axis Security Camera?
If the LED display on your Axis Security Camera isn't working, the camera might be in silent mode, which turns off the display. To resolve this, press the top button for 2 seconds.
Why Axis Security Camera doesn't turn on?
There are several reasons why your Axis Security Camera might not be turning on. It could be in shipping mode, in which case you should add the camera to the body worn system. Another possibility is that the camera battery is completely discharged; try charging the camera. If charging doesn’t resolve the issue, press and hold the power button for 4 seconds, then dock the camera until it’s charged. If you don’t have a docking station, press and hold the power button for 4 seconds and charge the camera using a USB charger.
Why are my Axis W10 Security Camera recordings offloading slowly?
If your Axis Security Camera recordings are slow to offload, it might be due to multiple simultaneous offloads affecting the transfer speed. To resolve this, check the camera status in AXIS Body Worn Manager and wait for the recordings to be transferred.
General| Frame Rate | Up to 30 fps |
|---|---|
| Lens Type | Fixed |
| Night Vision | Yes |
| Weather Resistance | Yes |
| Connectivity | Wi-Fi |
| Wireless | Yes |
| Network Protocols | HTTP, HTTPS, RTSP, RTP, TCP, UDP, DHCP, DNS |
To Next Page
