Axxess ASWC-1 - Resetting Dual Assignment; Troubleshooting the Auto-Detect Mode; Auto-Detect Troubleshooting Steps

To reset a button back to its original use, repeat step 1 above. Then press the
“Volume down” button. The LED will go out and the long press mapping for the
button will be
erased.
Button
New Button
Number
Assignment
1
Not allowed
2
Not allowed
3
SEEK UP/NEXT
4
SEEK DOWN/PREV
5
MODE/SOURCE
6
MUTE
7
PRESET UP
8
PRESET DOWN
9
POWER
10
BAND
11
PLAY/ENTER
12
PTT
13
ON HOOK
14
OFF HOOK
15
FAN UP
16
FAN DOWN
17
TEMP UP
18
TEMP DOWN
Troubleshooting the Auto-Detect Mode
So you tried the auto-detect feature and at the end the LED did not stay on solid red, it
started flashing, that means the ASWC did not detect the vehicle. Follow these steps
to determine what happened:
First some basic steps:
1) Verify that you have 12 volt accessory and a good chassis ground to the ASWC-1.
2) Verify with the vehicle information sheet from the Axxess website
(www.axxessinterfaces.com) that you connected the correct steering wheel
control wire(s) in the vehicle to the correct wire(s) on the ASWC-1.
3) Verify that the 3.5mm connector is connected to your radio securely and in the
correct location.
4) If using the female 3.5mm connector on an Eclipse, JVC, or Kenwood radio,
verify that the radio’s SWC wire is connected to the correct wire on the ASWC-1.