Axxess ASWC-1 User Manual (English)

To Previous Page

Manual Programming:

* Note: Not every radio will have all the possible SWC commands on the steering

wheel. Aftermarket radios that do not have Bluetooth will not recognize the PTT (Push

To Talk) or On Hook / Off Hook commands, however those buttons can be manually

programmed to do other commands. Please refer to the radios owners’ manual or

wireless remote for specific commands the radio will recognize.

1) Complete connections to the vehicle and the aftermarket radio, making sure the 3.5mm

connector is connected.

* If this is the first time the ASWC is being installed in a vehicle:

2) Turn the ignition on; the led will start flashing rapidly

3) After 10 seconds the ASWC will go into the LED feedback mode. After the series of led

flashes the led will stay in a slow constant flash state. Go to step 4.

Or * If the ASWC has been in a vehicle before:

2) Press and hold the reset button down for more then 10 seconds.

3) After the 10 seconds the led will begin a slow constant flash.

4) At this point press and hold the Volume Up button on the steering wheel for 7 seconds

until the led goes solid red. Now release the Volume Up button and the led goes off. Volume

Up has now been programmed.

5) Now press and hold the Volume Down button until the led goes solid red. Release the

Volume Down button and the led goes off. Volume Down has now been programmed.

6) At this point press and hold the next button on the steering wheel that corresponds with

the programming list (see below). The chart below shows in what order the steering wheel

control buttons need to be programmed in.

If the next function on the list is not on the steering wheel press and hold the Volume Up

button for 1 second till the led comes on then release the button. This tells the ASWC

that the function is not available and moves on to the next function.

Other manuals for Axxess ASWC-1

Need help?

Do you have a question about the Axxess ASWC-1 and is the answer not in the manual?

General

Type	Steering Wheel Control Interface
Voltage	12V DC
Compatibility	Compatible with most aftermarket radios and vehicles with steering wheel controls
Vehicle Integration	Connects aftermarket radio to factory steering wheel controls
Programming	Auto-detects vehicle and radio, customizable button assignments
Firmware Updates	Updatable via USB
Data Retention	Retains settings even after battery disconnection
Function	Allows control of aftermarket radio functions from the steering wheel