Azbil AUR355 - Continuous Data Write Command (WS Command)

16
Chapter 4. Communication

Continuous data write command (WS command)
This command writes data to consecutive addresses.
z
Command message
Example of setting “UV flame detector check (combustion time)” for Event Settings
(2)(1) (3) (4)
(1) Command
(2) Data delimiter
(3) Write start address
(4) Write data (1st word)
(5) Write data (2nd word)
W
0S , 7 1 0 W 1, 0
(2)
, 5 3
(2) (5)
z
Response message
0

Normal end
0

When there is an error/warning
X X
The end code (error/warning) is entered in place of XX.
(1)
(1)
(1) End code