2-3
Chapter 2: Installation
2) End-installation type compressed air cleaner
If fundamental measures cannot be taken on main lines due to problems related to,
for example, control valve installation, install an end-installation type compressed air
cleaner (oil mist removal equipment) and supply instrumentation air to the device
through this compressed air cleaner.
[Equipment usage examples]
l Products produced by SMC Corporation
• Mist separator
AM150 and AM250 series
(Filtration rate: 0.3 μm; secondary oil mist concentration: 1.0 mg/m
3
)
• Air combination
Filter regulator + mist separator
AW30 series (filtration rate: 5 µm) + AFM30 series (filtration rate: 0.3 µm)
l Products produced by CKD Corporation
• Oil mist filter
M1000 and M3000 series
Mantle S type (filtration rate: 0.3 µm; residual oil: 1.0 mg/m
3
)
Note
Select compressed air cleaner specifications in accordance with the usage conditions.
Even if the oil mist removal equipment mentioned above is installed, appropriate in-
spections and maintenance of the pneumatic circuit are necessary for stable long-term
operation. Be sure to accompany the installation of oil mist removal equipment with
periodic inspections and maintenance.
Any failures of this device which are caused by unsatisfactory quality of the instrumen-
tation equipment air are not covered by the warranty.
To Next Page
Loading...
Need help?
General
