8-2
8-3. Disassembly of side assembly of side handwheel
Before starting disassembly, check that the pointer is set at the AUTO position. (Refer to
Figure 8-1)
(1) Loosen the bolt 6 which connects the levers 2 and then disengage the levers from the
pointer.
(2) Undo the mounting-bolts 1 of the side handwheel unit and detach it from the actuator.
(3) Remove the lock nut of the handwheel and then remove the handwheel.
(4) Loosen the bolt 8 of the bearing holder and then remove the feed shaft 7.
To assemble the side handwheel, refer to Figure 8-1 and follow the disassembly procedure in
the reverse order.
To Next Page
Loading...
