BAFANG DP C10.UART - Page 14

14
5.6 Display Backlight Brightness
When the speed field displays bL1, press
/
to choose a figure between 1 and 5. The figure 1
represents the lowest brightness while 5 indicates
the highest display backlight brightness.
After this setting, briefly press
(< 0.3 seconds)
to enter the setting interface of automatic off time.
USER MANUAL DP C10.UART
5.5 Light Sensitivity
When the speed field displays bL0, use
/
to choose a figure between 0 and 5. The higher the
chosen figure, the higher the light sensitivity.
After this setting, briefly press
(< 0.3 seconds)
to enter the setting interface of backlight brightness.
OVERVIEW OF PRODUCT
5.4 km/mile
When the speed field displays S7, press / to
switch between km/h and mph, or to set km or mile.
After this setting, briefly press (< 0.3 seconds)
to enter the setting interface of light sensitivity.