For battery igniter models, set the energy
selector switch to position OFF (2). The
appliance is switched off.
Release the locking mechanism of the door
lock by pushing it in and moving to the front. If
the door is shut in this position, a small gap is
nevertheless kept open to prevent formation of
mildew (Fig. 38-39).
If the refrigerator is to be taken out of service
for an extended period of time, close the
onboard shut-off valve and the cylinder valve.
If it is necessary to remove these storage
racks (1) (i.e. for cleaning), first loosen the
locking pins (2) as shown with a suitable
screwdriver. The storage racks may be pulled
out by loosening the two locking devices (3)
underneath. For loosening pull the slider to
the middle, for fastening pull them sidewards.
• Switch the refrigerator on approx. 12
hours before filling it.
• Always store pre-cooled foods in the
refrigerator. Make sure that the food is
well cooled when it is bought and also
when transporting it. Use insulated
cooling bags.
• Open the refrigerator door only for a
short period of time when removing
products.
• Products must be packed - best of all in
closed containers, wrapped in aluminium
foil or similar - and stored separately from
each other, in order to prevent drying out
or odours.
• Allow foods that have been warmed up to
cool down before storing.
• Avoid storing products in the refrigerator
that could emit volatile flammable gases.
• Do not overfill the storage grids and
compartments to prevent obstructing the
internal air circulation.
• Maintain a clearance of approx. 10 mm
between chilled products and post
evaporator (“cooling fins”).
• Do not expose the refrigerator to direct
sunlight. Please bear in mind that the
temperature inside a closed vehicle
increases sharply if exposed to sunlight
and that this can reduce the efficiency of
the refrigerator.
• Ensure that air circulation of the
cooling unit is not obstructed. Keep the
ventilation grilles free from obstructions.
To Next Page
Loading...
