● When in channel scan display mode, check or set the alerts ,
it will automatically exit channel scan display mode.
● When in current outdoor sensor channel, the alert symbol will
continue flashing on the screen until alert value is out of alert range.
● Four temperature alerts setting: indoor and outdoor 3 channels.
Notes:
1. After power on ,the indoor humidity will display automatically, it
will update reading each 30 seconds and start to receive outdoor
signal which lasts for max 3 minutes.
2. Humidity display range: 1%-99%;for humidity lower than 1%,the
reading will be “1%”;for humidity higher than 99%,the reading will
be “99%”.
3. Accuracy: when the humidity is between 30-80%,the accuracy is
±5%,if out of this range the accuracy will be ±7%.
HUMIDITY
Temperature Alerts Setting
1. When in time display mode, press and hold “ALERTS ” button to
enter temperature alerts setting. The temperature alert value will
be flashing.
2. Alerts setting order: Outdoor High Temperature Alert→ Outdoor
Low Temperature Alert → Indoor High Temperature Alert →Indoor
Low Temperature Alert → Exit.
3. Press “▲/ CH ” or “ ▼/RCC ” button to adjust the value.
Hold to adjust quickly.
4. Press “ALERTS” button to confirm and move to next alert setting.
5. During setting, touch top button to save and exit setting.
6. During setting, if no operation for 20 seconds, it will automatically
save and exit setting.
15
To Next Page
Loading...
