The BNI EIP-302 module includes an internal webserver to get detailed information about
the current state. Also you can use it to configurate the module.
First make sure that a correct integration into your network has been done. To get a
connection to the webserver enter the IP address of the module to your browser address
bar. A welcome page with a list of all Balluff Ethernet Network-interfaces is shown.
Please use Internet Explorer 7 or higher.
By click on “play”-button “Home” active.
You can get some information about the configuration and network-activity of the module.
At the top of the window you can see the navigation bar which allows you to switch between
the different webpages, just click on the corresponding text.
On this page you can get some information about the module’s current process data by
having a look at the leds.
On this page you can see the current module and network status like you can see it on the
module itself.
The configuration page allows you to configure the module. You can change network-
parameters and also assign own module information texts like a module description.
This can only be used by entering a username and a password:
Username: Balluff
Password: BNIEIP
To Next Page
Loading...
