This guide describes The BNI EIP-… serves as a decentralized input and output module for
connecting to an EtherNet/IP™ network.
Installation and startup are to be performed only by trained specialists. Any damage
resulting from unauthorized manipulation or improper use voids the manufacturer’s
guarantee and warranty.
The device is in accordance with EMC Class A. Such equipment may generate RF noise.
The operator must take precautionary measures accordingly.
The device must be powered only using an approved power supply (see chapter 4
“Technical data”). Only approved cable may be used.
Operating and testing
The operator is responsible for observing local prevailing safety regulations.
When defects and non-clearable faults in the device occur, take it out of service and secure
against unauthorized use.
Approved use in ensured only when the housing is fully installed.
Caution!
The pictogram used with word ”Caution“ warns of a possible hazardous situation
affecting the health of persons or equipment damage. Ignoring these warnings can
result in injury or equipment damage.
Always observe the described measures for preventing this danger.
To Next Page
Loading...
