• Installation settings are defined during commissioning of the
autopilot system. No changes should later be done to these
settings
Both user settings and installation settings depends on which
autopilot computer that is connected to the system.
The following sections describe the settings that can be changed by
the user. The settings are described per autopilot computer.
Installation settings are available in the documentation following
the autopilot computers.
H5000 Autopilot computer
Performance (H5000)
The Performance controls the response of the autopilot steering.
There are five levels of performance modes:
• Level one consumes the least amount of power when steering
the autopilot and offers the slowest response
• Level five consumes the most power and has the highest
response
The performance mode is indicated in the top left corner of the
autopilot page.
Steering (H5000)
This option allows for manually changing parameters that were set
during the commissioning of the autopilot computer. For more
details of the settings, refer to the separate documentation for the
autopilot computer.
48
Autopilot | Triton2 Operator manual
To Next Page
Loading...
Need help?
General
