To Next Page

To Previous Page

• Select data: Used for defining which data that should be

displayed on the selected HV display

• White backlight: Sets the the backlight to white

Note: This option is not available for the 40/40 HV display

• Display group: Sets the network group for the unit

• Instance: Sets the network instance for the unit

For more information about network groups and instance settings,

refer to "Network" on page 69.

Calibration

Note: Once the unit is setup and before you proceed with

calibration ensure all network sources are selected and

configured. Refer to "System settings" on page 69.

Boat speed

Speed calibration is necessary to compensate for hull shape and

paddlewheel location on your boat. For accurate speed and log

readings, it is essential that the paddlewheel is calibrated.

SOG reference

This is an auto calibration option that uses speed over ground (SOG)

from your GPS, and compares the average of SOG against the

average boat speed from the speed sensor for the duration of the

calibration run.

Note: This calibration should be made in calm sea with no

effect from wind or tidal current.

Software setup | Triton2 Operator manual

Questions and Answers:

Need help?

Do you have a question about the B&G Triton2 and is the answer not in the manual?

B&G Triton2 Specifications

General