Simulate
Runs the display with simulated data. Use the simulator to become
familiar with your unit before using it on the water.
When activated, the simulator mode is indicated on the display.
Restore defaults
Allows you to select which settings are to be restored to their
original factory settings.
Engine setup
Vessel setup
Set the number of engines, fuel tanks and total fuel capacity.
Engine display setup
A maximum of two engine’s data can be shown on each gauge.
The Engine display setup defines which engine’s data should be
displayed on a gauge if you have more than 2 engines.
Gauge limits
Sets the RPM and vessel fuel rate limits.
Ú
Note: These limits are a visual guide on the data pages. They do
not set any alarms.
Global reset
Resets the source selection on all displays connected to the
network.
About
Displays copyright information, software version, and technical
information for this unit.
74
Software setup | Triton2 Operator manual
To Next Page
Loading...
Need help?
General
