Bandit
36
Copyright 12/17
MODELS 2890SP/2900T MAINTENANCE
3 MONTH MAINTENANCE
1. Hydraulic oil lter:
Must be replaced after FIRST 10 HOURS OF
OPERATION, USE A 10 MICRON FILTER. After
hours. Located in the hydraulic tank.
2. High pressure and charge lters:
Must be replaced after FIRST 10 HOURS OF
OPERATION. After first change replace high
hours. There are either two or three located under
the oil cooler housing cover and the inspection
cover between the hydraulic tank and the control
box, depending on the hydraulic valve installed on
the machine.
3. Hydraulic suction screen(s):
Change hydraulic suction screen(s) yearly or every
2000 hours.
YEARLY MAINTENANCE
1. Fuel tank:
Drain and clean the fuel tank yearly.
2. Hydraulic oil:
tank.
DO NOT go near the rotating cutter wheel
for any reason. DO NOT go near the
cutter wheel while the engine is running
or the cutter wheel is coasting to a stop.
Contact with a rotating cutter wheel will
result in serious bodily injury or death.
D-63 1/17
DANGER
!
To Next Page
