Bandit
40
Copyright 12/17
MODELS 2890SP/2900T
CHECK
# DESCRIPTION DAY WEEK MONTH PROCEDURE
1 Cutter Wheel Arm Pivot Bushings X
2 Grinder Bearings (Belt Driven) X
3 Steering Axle Pivot Bushing X
4 Steering Bushings X
5 Swing Pivot Assembly Bushings X
6 Cylinder Lug Pin Bushing X
7 Swing Out Pivot Bushings (if equipped) X
8
Steel Friction Areas: pivoting,
hinged, sliding, rolling
X
Lubricate (i.e. cutter wheel guard,
control box doors
9 Grading Blade Pivot Bushings X
LUBRICATION CHART - 2890SP
Use as a reference only, locations may vary depending on options or component manufacturer.
Lubrication point instructions are described on the machine, in the Lubrication & Coolant
Section and Maintenance Section of this manual, or component manufacturer’s manual.
NOTICE
parts stores.
6
6
6
7
5
5
6
6
6
To Next Page
Loading...
