Bandit
54
Copyright 12/17
MODELS 2890SP/2900T
Alternate hydraulic oils are available, but they do not equal the performance or longevity
of the “Hydrex XV” oil. Consult the following information supplied by the oil distributor.
HYDRAULICS
requirements. Consult their manufactures manual for that information.
NOTICE
increase dramatically above ambient air temperatures during operation. The actual viscosity needed is
:
Minimum Viscosity during operation = 12 cSt
Maximum No-Load Viscosity at start-up = 2000 cSt
against metal-to-metal contact under increasing temperature, and their ability to separate water from
at higher temperature and thicken slower at colder temperatures allowing a wider operating range.
Based on the varying temperatures of the area where Bandit equipment is used, and the high demand
XV All Season Hydraulic Fluid for maximum protection and performance.
NOTICE
CELSIUS (C) -40 -34 -29 -23 -18 -12 -7 -1 +4 +10 +16 +21 +27 +32 +38 +43 +49 +54
FAHRENHEIT (F) -40 -30 -15 -10 0 +10 +20 +30 +40 +50 +60 +70 +80 +90 +100 +110 +120 +130
ANTI-WEAR HYD. OIL NO. 68
ANTI-WEAR HYD. OIL NO. 46
ANTI-WEAR HYD. OIL NO. 32
ANTI-WEAR HYD. OIL NO. 22
HIGH VI - ANTI-WEAR HYD. OIL NO. 46 (>140 VI)
PETRO CANADA HYDREX XV (245 VI)
HYDRAULICS
To Next Page
Loading...
