Bandit
57Copyright 12/17
MODELS 2890SP/2900T
requirements. Consult their manufactures manual for that information.
and hoses should be re-checked for leaks and clearances.
DO NOT UNDER ANY CIRCUMSTANCES OVER-SET THESE RELIEF PRESSURES, BECAUSE IT WILL
CAUSE DAMAGE TO COMPONENT PARTS AS WELL AS HYDRAULIC PARTS.
subject to change!
When returning hydraulic components for warranty make sure to box up all warranted parts to avoid additional
damage while shipping. Do not disassemble any hydraulic components which are to be warranted.
Anything which has been disassembled or tampered with will not be warranted. Items being returned must
be clean. All hydraulic components must have all hosing ports plugged. Failure to plug ports will allow debris
to enter components which will void warranty.
DO NOT operate this machine unless all hydraulic control devices operate properly. They must function,
shift and position smoothly and accurately at all times. Faulty controls can cause personal injury!
It is very important after you have operated a new machine for approximately an hour to shut down the machine
DO NOT GO NEAR HYDRAULIC LEAKS! High pressure oil easily punctures skin causing serious injury, gangrene,
your bare hands. Allow system to cool down to ambient temperature before opening any coolant or hydraulic oil
system.
In cold weather situations let your hydraulic system idle for approximately 15 minutes to allow the system to warm
up to operating temperature.
HYDRAULICS
HYDRAULICS
NOTICE
WARNING
!
WARNING
!
NOTICE
NOTICE
CAUTION
!
NOTICE
In cold weather situations, let the hydraulic system idle for approximately 15 minutes to allow the system
to warm up to operating temperature. Running cold oil through the hydrostatic motor can raise the case drain
pressures and damage the shaft seals.
NOTICE
DANGER
!
Before attempting any type of maintenance, disengage clutch or cutter wheel engagement, wait for the
engine, remove the ignition key, make sure the ignition key is in your possession, install the cutter wheel lock
pin, wait 2 minutes then disconnect the battery.
To Next Page
Loading...
