Bandit
71Copyright 12/17
MODELS 2890SP/2900T
Nuts, bolts, washers, and all other components can be ordered by physical description.NOTICE
CUTTER WHEEL ARM COMPONENTS
BELT DRIVEN
LOCATION PART NUMBER DESCRIPTION
1. 992-3001-53 Chip Pan Curtain
2. 992-3001-16 Chip Pan Strap - Short
3. 989-300861 Chip Pan Strap - Long
4. 992-2000-68 Chip Pan
5. 900-4906-70 1/2”-13NC x 1” Hex Head Bolt
6. 900-4906-86 1/2” Lock Washer
7. 989-300006 Cutter Wheel Shaft Washer
8. 900-1914-23 Cutter Wheel Bearing
9. 900-4906-84 1/2”-13NC Automation Lock Nut
10. 900-4909-18 1/2” Mill Carb Washer
11. 989-301354 Cutter Wheel Spacer
12. 900-1908-86 Bushing for Mount Hub
13. 989-300754 1/2” x 2” Key
14.
15. 989-300753 Cutter Wheel Shaft
16. 989-301351 Cutter Wheel Mount Hub
17. 900-4909-32 1/2”-13NC x 3” Hex Head Bolt (Full Thread)
18. 989-301355 Cutter Wheel Spacer
19. 900-1911-39 Sprocket for Poly Chain Belt Drive
20. 900-1906-01 Bushing for Poly Chain Belt Drive
21. 900-1915-11 Poly Chain Belt Drive
22. a. 989-1001-83 Beltshield Assembly
b. 989-2000-90 Beltshield Clean-Out Door Only
c. 989-3014-28 Beltshield Slot Cover
d. 989-2001-09 Beltshield Back
e. 989-3014-83 Beltshield Cover
23. a. 900-1911-03 Hydrostatic Motor Bushing (Start 1/10)
b. 900-1902-04 Hydrostatic Motor Bushing (Pre 1/10)
24. 900-1915-28 Hydrostatic Motor Sprocket
25. a. 989-100097 Hydrostatic Motor Mount
c. 900-4907-06 5/8”-18NF Hex Nut (Not Shown)
26. 989-300497 Pivot Mount Top for Hydrostatic Motor Mount
27. 989-200006 Upper Frame Assembly (Includes 26)
28. 989-2000-88 Cutter Wheel Guard
29. 900-4907-60 3/16” x 3” Cotter Pin
30. 900-4907-23 1 1/2”-6NC Slotted Hex Nut
31. 900-4913-47 1 1/2” Mill Carb Washer
32. 989-300982 Cutter Lift Pivot Pin
33. 900-1908-37 Split Bushing - 1 3/4” OD x 1 1/2” ID x 1 1/2”
34. 900-1912-83 Split Bushing - 1” OD x 3/4” ID x 2”
35. 900-3943-13 Hydrostatic Motor for Belt Driven Cutter Wheel (Not Shown)
To Next Page
Loading...
