Setup variable ‘EQ 1’ - allows you to set default bass and treble settings for use with all input sources. Many
systems allow only adjustment of bass and treble levels at fixed frequency points. Your processor allows you to
adjust level and frequency to aid in adjusting your room for a flat frequency response. Set bass and treble to the
values you would like have restored into the variable ‘EQ 1’ whenever your unit comes out of sleep (see Select
variable ‘EQ 1’ under OPERATION Equalization).
SETUP ROOM EQUALIZATION
Test Tone 100.0 Hz Off
Notch 100.0 Hz 0.0 dB
Notch Width 97.6 - 102.4 Hz
Bass 100.0 Hz 0.0 dB
Treble 10.0 kHz 0.0 dB
next item adjust
MENU setup system
127FK +=
100.0 Hz
return to SETUP SYSTEM
∠ MENU
MENU9
set to desired treble levelVOLUME KNOB
(REW) or
(FF)
8
move to Treble Level
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
7
set to desired treble frequencyVOLUME KNOB
(REW) or
(FF)
6
move to Treble Frequency
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
5
set to desired bass levelVOLUME KNOB
(REW) or
(FF)
4
move to Bass Level
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
3
set to desired bass frequencyVOLUME KNOB
(REW) or
(FF)
2
move to Bass Frequency
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
35
p/n 12857 Rev. 0717A
To Next Page
Loading...
Need help?
General
