activate ADVANCED ZONE B SETTINGS
↵ (ENTER)
SEL or ENTER2
move to Zone 2 Setup (B)
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
Zone 2 (B) Level Control - You may wish to install an in-wall volume control in your second zone. This can cause
confusion between your processor’s internal Zone 2 (B) volume controls and your in-wall controls.
WARNING - Setting Zone 2 (B) LEVEL CONTROL to FIXED will cause your processor to immediately send
its maximum Zone 2 (B) volume to your second zone (if Zone 2 (B) is on). Turn down your in-wall volume
controls before making this change.
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Fixed Level +15 dB
3 Zone ID 2
4 V2 Out
ut Ta
e
5 Link In
ut to Zone A No
6 Link Power to Zone A No
next item ad
ust
MENU advanced setu
1 Level Control Variable
=% /9/ 9$5,$%/(
ADVANCED ZONE B SETTINGS
1 Level Control Fixed
2 Fixed Level +15 dB
3 Zone ID 2
4 V2 Out
ut Ta
e
5 Link In
ut to Zone A No
6 Link Power to Zone A No
next item ad
ust
MENU advanced setu
1 Level Control Fixed
=% /9/ ),;('
adjust level to desired valueVOLUME KNOB
(REW) or
(FF)
2
move to Level Control
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
Zone 2 (B) Max (Fixed or Variable) Level - Z2 max level allows you to set a maximum volume level for Zone 2
(B). This is very useful if you are using speakers that can’t handle the maximum power output from your external
amplifier or if you simply wish to limit the volume that can be achieved using normal front panel or remote
operation. If you have chosen Zone 2 (B) level control (fixed), then this setting becomes the fixed level for Zone 2
(B). If you have chosen Zone 2 (B) level control (variable) then this setting allows the level for Zone 2 (B) to be
adjusted. However, when adjusting this level it cannot exceed the value set in Zone 2 (B) max level.
WARNING - If you set this level too low, the processor may appear broken (no sound).
ADVANCED ZONE B SETTINGS
1 Level Control Variable
2 Fixed Level +15 dB
3 Zone ID 2
4 V2 Out
ut Ta
e
5 Link In
ut to Zone A No
6 Link Power to Zone A No
next item ad
ust
MENU advanced setu
2 Fixed Level +15 dB
=% 0$; /(9(/
ADVANCED ZONE B SETTINGS
1 Level Control Fixed
2 Fixed Level +15 dB
3 Zone ID 2
4 V2 Out
ut Ta
e
5 Link In
ut to Zone A No
6 Link Power to Zone A No
next item ad
ust
MENU advanced setu
2 Fixed Level +15 dB
=% ),; /(9(/
adjust level to desired valueVOLUME KNOB
(REW) or
(FF)
2
move to Fixed Level
∧ (UP) or ∨ (DOWN)
(PAUSE) or
(STOP)
1
ActionFrom Front PanelFrom Remote
65
p/n 12857 Rev. 0717A
To Next Page
Loading...
Need help?
General
