EasyManua.ls Logo

Banner Sure Cross DXM700-Bx - ISM Radio Menu

Default Icon
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The user can force an immediate push to the webserver using Trigger Push. If a current push is in process it may take
several minutes to complete over cellular.
The Trigger Push submenu forces an immediate push to the web server.
The status and time fields indicate success or failure of the last attempted push and time of the last attempted push.
6.3 ISM Radio
The ISM Radio menu allows the user to view the Modbus ID of the internal ISM radio, enter binding mode, or run a site
survey. This top-level ISM Radio menu is different from the System Config > ISM Radio submenu.
The first option under the ISM Radio menu only displays the type of radio in the DXM700 (MultiHop or DX80 Star) and the
Modbus ID of the radio. To change the ISM Radio Modbus ID refer to the System menu.
Select Binding to enter binding mode or select Site Survey to run a site survey.
Figure 27. ISM Radio menu
ISM Radio
MultiHop/DX80 ID
Binding
Site Survey
Bind to > 1
Node/Modbus ID > 1
to change the value
to accept
ENTER
BACK
to return to the previous menu
Please Wait...
Site Survey results OR Failed to start Site Survey
Binding— All ISM radio devices must be bound to the internal Gateway/master device before the DXM700 can access the
wireless devices. The first submenu under binding allows the user to set the wireless address of the device to bind with. This
is required to bind with wireless devices that do not have rotary dials (for example: M-GAGEs, ultrasonic sensors, and Q45
devices). See Binding and Conducting a Site Survey with the ISM Radio on p. 11. For more information on binding a
particular device, refer to the individual datasheet.
Site Survey—After creating a wireless network using the binding process, run a site survey on each device to see the link
quality. See Conduct a Site Survey from the DXM on p. 12.
6.4 I/O Board
The DXM700 does not have an I/O board. DXM700 has four outputs accessed using Modbus registers.
Sure Cross
®
DXM700-Bx Wireless Controller
38 www.bannerengineering.com - Tel: + 1 888 373 6767

Table of Contents

Related product manuals