Banner Sure Cross DXM700-Bx - Email and Text Messaging Setup

The following table shows DXM local registers 1, 5, and 10 being written from the EIP controller using assembly instance
112. Only registers 1, 5, and 10 are defined in the DXM Configuration Software as EIP Originator -> DXM registers.
Table 21: EIP Originator -> DXM register mapping
EIP Assembly Instance 112 DXM Local Registers
Adrs Data Adrs Data
00 11
01 11 22
01 22
02 33
05 33 44
03 44
04 55
10 55 66
05 66
The following table shows DXM local registers 10, 11, and 19 defined as EIP DXM -> Originator. The lower 2-bytes of each
register data is placed into assembly instance 100.
Table 22: EIP DXM -> Originator register mapping
EIP Assembly Instance 112
DXM Local Registers
Adrs Data Adrs Data
00 77
10 77 88
01 88
02 99
11 99 10
03 10
04 11
19 11 12
05 12
8.5 Setting up Email and Text Messaging
The DXM can be configured to send email or SMS messages based on threshold conditions.
Important: Only the DXM100 and DXM150 models offer SMS/text messaging capabilities.
Cellular-connected systems can use email or SMS. Ethernet-connected systems can only use email, but can send email to
cellular phones as a SMS message depending upon the network carrier. To send email to a Verizon phone, use the phone
number followed by @vtext.com, for example, 1234567890@vtext.com.
For more information, refer to the DXM Configuration Software Instruction Manual (p/n 209933). Internal log files may be sent
using email. Follow these instructions and use the DXM Configuration Software to program the controller for email and/or
SMS.
1. On the Settings > System screen, set the Device Time on the DXM700.
2. On the Settings > Cloud Services screen, select either Ethernet or Cell for the Push Interface.
3. If you selected Ethernet, configure your Ethernet connection by setting the IP settings on the Ethernet screen. If you
selected a Push interface of Cell, use the Cellular screen to define parameters.
4. Set the email and message parameters on the Notifications screen.
5. To send alert messages, define the threshold rule to use email and/or SMS.
6. To send log files, define the log file parameters.
8.5.1 Mail Server Authentication
Complete the mail server settings to have the DXM700 send email alert messages or to email the log files.
The SMTP password is stored in the DXM700, not the XML configuration file. Use the Settings > Notifications screen to
complete this configuration.
Sure Cross
®
DXM700-Bx Wireless Controller
52 www.bannerengineering.com - Tel: + 1 888 373 6767