9.5.2 Change the Device IP Address
Follow these instructions to change the IP address of the DXM device using the Siemens TIA Portal (v14) software. Use
these instructions as a basis if you are using another controller (PLC).
1. Launch the Siemens TIA Portal (v14) software.
2. Click Open existing project.
3. Select a project and open it.
4. Click Devices & networks.
Figure 48. Network view
The Network view displays.
5. Double-click on the DXM icon to open the Device view screen.
6. Click on the DXM icon in the graphic area of the Device view screen.
The Module properties window displays and the module can now be configured.
7. Click Properties.
8. Click General.
9. Select PROFINET Interface > Ethernet addresses.
Figure 49. Ethernet addresses
10. Select Set IP address in the project.
11. Enter the IP address.
12. Right-click on the device icon and select Online & diagnostics.
Sure Cross
®
DXM700-Bx Wireless Controller
62 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
