EasyManua.ls Logo

Banner Sure Cross DXM700-Bx - Configure Your Cellular Connection; Set the Email and Messaging Parameters

Default Icon
73 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Figure 41. Settings > Ethernet screen
8.5.4 Configure your Cellular Connection
To use a cellular connection, select Cell as the network connection on the Settings > Cloud Services screen (see Configure
the DXM Controller for a Cellular Modem on p. 36). The Cellular screen does not display unless the Network interface is
set to Cell.
Using a 4G LTE cell module requires a cellular plan; follow the instructions on p/n 205026 to activate a cell modem.
1. On the Settings > Cellular screen, select your cellular modem from the drop-down list.
2. Set the APN.
If you are using a Banner 4G LTE Verizon Module (LE910), set the APN to vzwinternet.
If you are using an Emnify 3G GSM Cellular Radio (HE910), set the APN to EM. This module does not require
an APN username or password.
If you are using a third-party SIM card, the APN, APN Username, and Password must be provided by the
cellular service provider.
8.5.5 Set the Email and Messaging Parameters
From the Settings > Notifications screen, enter the SMTP definition, login, and password for a mail server.
Important: Only the DXM100 and DXM150 models offer SMS/text messaging capabilities.
To send email, you must supply the SMTP Server, Server Port, and login credentials. When you are only sending SMS
messages over cellular, the SMTP Server is not required.
The default SMTP port is 25 but may need to be adjusted for Ethernet-based networks. Note that many facilities block port
25. Port 587 is another common SMTP submission port.
The SMTP password is not stored in the XML configuration file, but on the DXM700. After the password is entered, click on
Send SMTP Password to send it to the DXM700. The password is stored in non-volatile memory, so reboot the DXM700 to
recognize the new password.
When using a GMail server, select Situational encryption and Enable SMTP authentication. The GMail server will not
allow you to send email alerts using the cellular interface. GMail may notify you that you must allow access for less secure
apps in your email settings.
For other email servers, the parameters may vary and will require information from the provider.
Sure Cross
®
DXM700-Bx Wireless Controller
54 www.bannerengineering.com - Tel: + 1 888 373 6767

Table of Contents

Related product manuals