4.4.2 Antenna Installation
Antenna Installations. Install and properly ground a qualified surge suppressor when installing a remote antenna sys-
tem. Remote antenna configurations installed without surge suppressors invalidate the manufacturer's warranty. Keep the ground wire
as short as possible and make all ground connections to a single-point ground system to ensure no ground loops are created. No surge
suppressor can absorb all lightning strikes; do not touch the SureCross
®
device or any equipment connected to the SureCross device
during a thunderstorm.
4.4.3 Mounting an RP-SMA Antenna Directly to the Cabinet
This antenna mounts directly to the outside of the box, with the SureCross device mounted inside the box.
Model Number Description
1 BWA-9O2-C Antenna, Omni, 902-928 MHz, 2 dBd, Rubber Swiv-
el, RP-SMA MALE
BWA-2O2-C Antenna, Omni, 2.4 GHz, 2 dBd, Rubber Swivel, RP-
SMA MALE
BWA-2O5-C Antenna, Omni, 2.4 GHz, 5 dBd, Rubber Swivel, RP-
SMA MALE
BWA-2O7-C Antenna, Omni, 2.4 GHz, 7 dBd, Rubber Swivel, RP-
SMA MALE
2 BWC-LMRSFRPB Surge Suppressor, Bulkhead, RP-SMA Type, 900
MHz/2.4 GHz
3 BWC-1MRSFRSB02 RG58 Cable, RP-SMA TO RP-SMA Female Bulkhead,
0.2 m
BWC-1MRSFRSB1 RG58 Cable, RP-SMA TO RP-SMA Female Bulkhead,
1 m
BWC-1MRSFRSB2 RG58 Cable, RP-SMA TO RP-SMA Female Bulkhead,
2 m
BWC-1MRSFRSB4 RG58 Cable, RP-SMA TO RP-SMA Female, Bulkhead,
4 m
4 DIN-35-105 DIN Rail section, 105 mm long, 35 mm design
5 SMBDX80DIN DIN Rail Bracket Assembly for DX70 and DX80
models.
4.4.4 Mounting an RP-SMA Antenna Remotely
This antenna mounts remotely from the box, with the SureCross device mounted inside the box.
This configuration may be used either inside or outside the building; a Yagi antenna is usually used in outdoors applica-
tions while an omni-directional antenna may be used either inside or outside a building.
SureCross DX80 and Performance DX80 Product Manual
Rev. J www.bannerengineering.com - tel: 763-544-3164 25
To Next Page
Loading...
