On the Gateway use the DERR menu to clear, disable, or ignore error messages generated by devices within the net-
work. The Node number that generated the error and the error code (EC) display onscreen. Single-click button 1 to ad-
vance through the menu of CLEAR (clear this particular instance of the error from the system), DISABL (disable this partic-
ular error from appearing from this specific Node), and IGNORE (ignore this error but do not remove it from the system).
After the error messages for a Node are cleared, disabled, or ignored, errors for any additional Nodes display on the Gate-
way’s LCD.
On the Node use the DERR menu to view and ignore error messages for that Node.
5.2 Web-based Configuration
The SureCross wireless systems are configured using an Ethernet network connection and a common Web page browser. An Ethernet
connection can be established from a GatewayPro or from a DX83 Ethernet Bridge serially connected to the Gateway.
The Ethernet Bridge and GatewayPro each ship with an Ethernet crossover cable. One end of the cable is a RJ45 connector
and the other end is an industrial Ethernet connector. This cable is designed to be connected directly to a computer.
5.2 Example Layout #1
When connecting a Gateway to a host system, the wireless network must be configured using the User Configuration Tool
(UCT). When you are not using a GatewayPro or Ethernet Bridge, you cannot configure the wireless network using the Web
Configurator.
1. Power connection
2. Splitter cable and Modbus RTU communication
3. Gateway
5.2 Example Layout #2
This system uses a GatewayPro connected directly to a host system using an Ethernet crossover cable. This system can be
configured using the web pages.
SureCross DX80 and Performance DX80 Product Manual
38 www.bannerengineering.com - tel: 763-544-3164 Rev. J
To Next Page
Loading...
