Icon Fault Code Device Status
OSSD
Status
Description
ENC OUT
OF FREQ
Lockout Off
The input received from encoder 1 or encoder 2 exceeds the maximum
pulse frequency. The scanner enters a lockout status after three
consecutive out-of-frequency events.
ENC ERROR Lockout Off
This error can occur if one of the following conditions is met:
•
The difference between the speed measures collected by encoder
1 and encoder 2 exceeds the encoder Δ (delta) beyond the
allowable time window.
• The encoders are not connected properly.
REMOTE
ERROR
Lockout Off
The master scanner is signalling that one of the remote scanners is in a fault
or error condition. Check the remote scanner's display for the fault code.
EDM Lockout Off
EDM error.
Check the connection of the EDM wire. Verify the delay setting matches the
relay characteristics. If necessary, replace the relay.
If the failure persists, contact the factory for support.
MEMORY
DOESN'T
MATCH
Boot Off
Memory device does not match with the configuration.
Replace the memory device with the correct model.
MEMORY
FAILURE
Boot Off
Memory device failure.
Create a new configuration using the software, perform a backup
configuration from the master device, or replace the memory device.
MEMORY
EMPTY
Boot Off
The memory device has no configuration stored on board.
Create a new configuration using the software or perform a backup
configuration from the master scanner.
DEVICE
EMPTY
Boot Off
The master scanner has no configuration stored on board.
Create a new configuration using the software or restore the configuration
from the memory device.
CFG NO
MATCHING
Boot Off
The device configuration does not match with the memory device
configuration. Follow the displayed instructions.
SX Safety Laser Scanner
110 www.bannerengineering.com - Tel: + 1 888 373 6767
To Next Page
Loading...
