Bante Instruments 9 Series - General Guide; Introduction; Environmental Conditions; Packing List

03 I General Guide
General Guide
This section is applicable to all models of meters
Introduction
Thank you for selecting the 9 series water quality meter, this product
series includes models below.
Single Parameter Meters
Model
Measurement Parameters
920
pH, mV, ORP
930
pH, mV, ORP, ion
931
Ion, mV
932
Water hardness
950
Conductivity, TDS, salinity, resistivity
980
DO
Multiparameter Meters
Model
Measurement Parameters
900
pH, mV, ORP, ion, conductivity, TDS, salinity, resistivity, DO
901
pH, mV, conductivity, TDS
902
pH, mV, ORP, conductivity, TDS, salinity, resistivity
903
pH, mV, ORP, DO
904
Conductivity, TDS, salinity, resistivity, DO
This manual provides a step-by-step guide to help you operate these
meters, please carefully read the following instructions according to
the model you have purchased. Any use outside of these instructions
may invalidate your warranty and cause permanent damage to the
meter.
Environmental Conditions
Before unpacking, ensure that current environmental conditions meet
the following requirements.
• Relative humidity is less than 80%
• Ambient temperature between 0° C (32° F) and 50° C (122° F)
• No potential electromagnetic interference
• No corrosive gas exists
Packing List
The following list describes all components of the meter. If any items
are missing or damaged, contact the supplier immediately.
Meter, electrode arm