high or low. The menu functions as follows:
1. Press【MENU】to enter menu mode.
2. Press【】/【】to set, then press【MENU】to select.
3. Press【】/【】to the radio setting, then press【MENU】to select.
4. Press【】/【】to transmitting power, then press【MENU】to select.
5. Follow the screen prompt to change the current Settings.
6. Press【MENU】to select new power level.
7. Return to the previous menu.
Press【BACK】return to the home screen, and screen displays the power level icon
An H above the screen indicates the current high power; M indicates the current medium power; L indicates
the current low power.
Setting screen backlight
You can turn on or off the screen backlight of the walkie-talkie if needed. This setting will also affect the back light
of the menu and numeric keyboard.
According to the pre-programmed backlight automatic on-off key, switches backlight Settings. The menu
functions as follows:
1. Press【MENU】to enter menu mode.
2. Press【】/【】to set, then press【MENU】to select.
3. Press【】/【】to the radio setting, then press【MENU】to select.
4. Press【】/【】to backlight, then press【MENU】to select.
5. The screen indicates normally open, 5S, 10S, 15S options, press【MENU】to select normally open, then screen
backlight is always open and light.
• Or if select 5S, 10S, 15S, the screen will turn off the screen backlight without any operation after the
corresponding time.
Setting squelch level
You can adjust the squelch level of walkie talkie, filters unusable calls of low signal strength or channels of
background noise that higher than normal value.
Normally it is default value (that is regular filtering); strictly filter unwanted calls or background noise, in the same
time, calls from remote locations can also be filtered out.
Press preprogrammed strict/normal squelch key to switch the squelch level between normal and strict.
The menu functions as follows:
1. Press【MENU】to enter menu mode.
2. Press【】/【】to set, then press【MENU】to select.
3. Press【】/【】to the radio setting, then press【MENU】to select.
4. Press【】/【】to squelch, then press【MENU】to select.
5. Choose strict or normal, then press【MENU】to select.
6. Press【BACK】return to the home screen.
Turn on or off the boot screen
If needed, you can enable and disable the boot screen display. The menu functions as follows:
1. Press【MENU】to enter menu mode.
To Next Page
Loading...
