Baofeng DM-1701 - Power on Password; Clock; Time; Date

when the microphone on the attachment with VOX function detects the voice, the radio will automatically
transmit the signal during the programmed time period.
Press the【PTT】during the radio operation will disable the VOX function, to re-enable the VOX function need
perform one of the following operations:
• Close and re-open the radio;
• Change channel through channel knob;
• Perform the following procedure:
Enabling or disabling this function that is limited to radio of activating these functions. The voice sensitivity
of VOX is set in the radio configuration.
To turn on or off this function by pre-programmed VOX open/close key.
The menu functions as follows:
1. Press【MENU】to enter menu mode.
2. Press【】/【】to set, then press【MENU】to select.
3. Press【】/【】to the radio setting, then press【MENU】to select.
4. Press【】/【】to the VOX, then press【MENU】to select.
5. The screen displays open, press【MENU】to enable the VOX function.
• Or the screen shows off and press【MENU】to turn off the VOX function.
 Power-on password
The menu functions as follows:
1. Press【MENU】to enter menu mode.
2. Press【】/【】to set, then press【MENU】to select.
3. Press【】/【】to the radio setting, then press【MENU】to select.
4. Press【】/【】to the power-on password, then press【MENU】to select.
5. Type the correct 8-bit password (can preset with the software), then press【MENU】to select.
6. If the password is incorrect, the screen displays the wrong password. Display options if the password is correct.
7. If the first line indicates open, press【MENU】 to display the power-on password application, and then you
need to type the correct password to start the radio at the next boot. If the first line indicates close, press
【MENU】 to display the boot password cancellation, and start the radio directly at the next boot.
8. Press【】/【】to change power-on password, then press【MENU】to select.
9. Type the new 8-bit password, then press【MENU】to select.
10. Type the new 8-bit password again, then press【MENU】to select.
11. Display password change successfully.
The power-on password must be set to 8-bit.
 Clock
Clock setting divided into:
• Time
• Date
• Time zone
 Time