Description of settings
Change the decoding of sub audio. Setting method is same as above
Change the coding of sub audio. Setting method is same as above
Low power transmission
High power transmission
ON; the function works only when “Allow offline” of current channel of
the host computer is ticked
Off
Narrowband works
Broadband works
Transmit when the channel is occupied
Press PTT to prohibit transmission when there is carrier wave
Match CTCSS / color code forbidden
Off, no transmission limit
Alarm in 10 seconds before transmission, and prohibit transmission
when the time is up; for example, when it is set to 60 seconds, alarm is
sent for 10 seconds from the 50th second, and transmission is
prohibited at the 60th second
VOX is turned off;
It is not necessary to press PTT when this option is on; you can speak to
transmit directly; voice sensitivity of the host computer can be set to 1~10,
level 1 is the highest sensitivity level, and level 10 is the lowest sensitivity level
The machine works in the main channel, the sub-channel can’t
transmit or receive
The machine works in the main channel, the sub-channel can’t
transmit or receive
33 34
Level 2 menu
CTCSS/DCS
Squelch
TX Power
Talkaround
N/W BAND
Busy Lock
TOT
Vox
Double Wait
R CTC/DCS
T CTC/DCS
Strict
Normal
Low
High
On
Off
Narrow
Wide
Off
Carry
QT/CC
OFF
15 ～ 495S
Off
On
Off
Double Wait
Level 1 menu Level 3 menu Options
Set Radio Set
Options
can be
config-
ured
Options
can be
config-
ured
The Software
menu options
are
configurable
For analog
mode only
Options can
be
configured
Options
can be
config-
ured
Remark
To Next Page
Loading...
